Dave Macfee writes:
I am looking for input and recommendations on a duplicator attachment I can
hopefully fit to my Delta Lathe. I want a duplicator that will cut copies using
the original part to be replaced as the pattern, instead of from a flat pattern.
Craig Cianciolo writes:
I am looking for input and recommendations on a duplicator attachment I can
hopefully fit to my Delta Lathe. I want a duplicator that will cut copies using
the original part to be replaced as the pattern, instead of from a flat pattern.
Craig Cianciolo writes:
This guy made a pretty good one which could easily be modified
to use a sample instead of a template.
John Coffey wrote:
>I have seen a copying gauge that has fingers so that when you've
>arrived at the correct diameter a 'finger' on the gauge falls through.
Craig Cianciolo replies:
You can make one of those, too. They look like this:
