Al Vendi writes:
Groop:
Once again I need to take a cool dip into the well of knowledge.
I'm having a problem with the finish on these chairs I'm trying to strip. I'm using M36 in my flow over tank and it doesn't seem to work very well. However, if I add some acetone to the mix then it improves. But it still requires a lot of scrubbing with a wire brush to get the finish off.
My question to groop is, can anyone identify the finish based on the photos? I'm guessing, but I believe it could be a polyester. I'm spending too much time on these and I still have five more chairs plus the table and leaf to complete. I'm looking for a solution that will reduce my time over the tank to remove this finish.
Your help, as always is greatly appreciated.
Groop:
Once again I need to take a cool dip into the well of knowledge.
I'm having a problem with the finish on these chairs I'm trying to strip. I'm using M36 in my flow over tank and it doesn't seem to work very well. However, if I add some acetone to the mix then it improves. But it still requires a lot of scrubbing with a wire brush to get the finish off.
My question to groop is, can anyone identify the finish based on the photos? I'm guessing, but I believe it could be a polyester. I'm spending too much time on these and I still have five more chairs plus the table and leaf to complete. I'm looking for a solution that will reduce my time over the tank to remove this finish.
Your help, as always is greatly appreciated.
Al Vendi
Armada, MI
Armada, MI
